Adjusting The Back Height; Adjusting The Armrest Height And Angle - Otto Bock MPS Instructions For Use Manual

Settings and use
6.6 Adjusting the back height
1� Remove the back pad (see Fig� 18)�
2� Use a Phillips head screw driver to loosen the set screw in the center of each knob which secure the back shell
and the laterals to the back (6 total knobs)�
3� Loosen the knobs to allow the two back plates to slide past each other�
4� Slide the back plates to the desired height and tighten down the knobs for the back and laterals�
5� Tighten the set screw in the center of each knob to prevent the knobs from loosening�
6� Replace the back padding tucking any residual length of the back pad into the gap between the seat and back�
6.7 Adjusting the armrest height and angle
1� Open the screws underneath the armrest�
2� Set the armrest to the desired height and angle, and retighten the screws (see Fig� 23)�
14 | Ottobock
18
20
22
19
21
23
MPS