Otto Bock MPS Instructions For Use Manual page 22

Settings and use
Adjusting the lateral supports
The lateral supports can be individually adjusted in height, width and depth�
1� Loosen the two mounting screws on the rear of the backrest�
2� Slide the lateral supports to the desired height and width along the slotted holes�
3� Retighten the screws�
Depth adjustment (only for size 2)
1� Remove the cover from the lateral supports�
2� Loosen the two screws and adjust to the desired depth along the slotted holes�
3� Retighten the screws�
4� Put the cover back on�
6.12.3.2 Abduction block
The seat can be equipped with an abduction block that ensures that the legs are abducted (spread to the sides) from
the center of the body for certain indications�
Mounting the abduction block
1� Remove the seat padding�
2� Set the abduction block against the front of the seat plate so that the slotted holes of the bracket line up with
the holes in the seat plate�
3� Screw the bracket to the seat plate (see Fig� 50)�
4� Put on the seat padding�
22 | Ottobock
48
50
49
MPS