Remak VCS Installation And Operating Instructions Manual page 51

Control (HMI-DM,HMI-TM controllers)
Figure 24 – Installation on a Wall
HMI-TM controller
Operating conditions
Degree of protection: IP 65 (version with magnetic fi xation).
Permissible ambient temperature: -20 °C to 60 °C. Relative
humidity: 5 % to 95 %.
Device Description
Dimensions of the HMI-TM controller are 173x95.5x21.6 mm.
Th e LCD display resolution is 128x96 pixels. Th e HMI-TM con-
troller is equipped with 6 function buttons, INFO, FAILURE,
ESC, UP, DOWN and ENTER. Th e INFO, FAILURE and ESC
buttons simultaneously indicate operating states (Stop – fail-
ure, operation). Th e UP, DOWN and ENTER buttons are used
to navigate through the menu. Th e magnetic plate on the rear
side of the HMI enables free attachment to metal objects.
Figure 25 – HMI-TM controller
Info
Failure
ESC
Table 2 – Function Buttons
Button
(Name)
Press
Up
Hold
Press
Down
Hold
Press
Enter
Hold
Press
Info
Flashing
green
Green light
Press
Failures
Flashing red
Red light
Up
Down
Enter
Press
Esc
Hold
Control units VCS
Activity Description
- Scrolling the list upwards
- Increases the parameter value
- Hold this button longer
than 1.5 s to speed up the
list scrolling upwards
- Increases the parameter
values in higher grades
- Scrolling the list downwards
- Decreases the parameter values
- Hold this button longer
than 1.5 s to speed up the
list scrolling downwards
- Decreases the parameter
values in higher grades
Selection/confi rmation
- When logged in, press and hold
for at least 3 s to go to the log-in/
log-out page.
- When not logged in at any access
level, the log-in page is displayed.
- Goes to the Main Menu from
the current menu page
- Goes to the Start Menu
page from the Main Menu
- Air-handling unit start-up sequence
- Air-handling unit operation
- Every time you press this button,
you will cycle through the following
pages → List of Failures → His-
tory of Failures → Alarm Settings
(failure confi rmation and reset)
- Active unconfi rmed failures
- Active confi rmed failures
- Cancels the change to
the parameter value
- Returns to the upper level of
the menu/previous page
- Returns to the last active page
before accessing the Pass-
word Administration page
- Returns to the last active page
before accessing the Home
page using the Info button.
- Moves to the HMI Settings page
49