Remak VCS Installation And Operating Instructions Manual page 104

PLC Controller for Compressor Output Control
Additional Display Views (P-79 parameter)
Code
Outr The sensor is out of the measuring range.
An06 Digital compressor discharge temperature.
An10 Evaporation temperature
An11 Condensation temperature
An12 Evaporation pressure
An13 Condensation pressure
An14 Inlet temperature 1
An15 Inlet temperature 2
AIL3 Input signal value (0 = 0V, 100 = 10V)
AIL4 LP sensor value (bar)
AIE4 HP sensor value (bar)
AOL3 Limiting value according to Te
AOE3 Limiting value according to Tc
AOE4 Condenser control analogue signal value
FrEE Electronics Menu active, only for service pur-
poses.
Technical Data
Packaging
Box
Panel degree of protection
Connection
Supply voltage
Input power
Display
Inlets
Additional inputs
Relay outputs
Triac outputs
Analogue outputs
Data memory
Operating temperature range
Storing temperature range
Relative humidity
Measuring and control range
Accuracy (at ambient temperature 25 °C)
102
Description
Self-extinguishing ABS plastic
Front panel, 32 × 74 mm, depth 80 mm
IP65
Screw terminal box for wires up to 2.5 mm2 cross-section
12, 24 V AC
Max. 6 VA
Four-digit, red LEDs, digit height 14.2 mm
Up to 5 sensors NTC (-40 to 110°C)
6x digital tension-free contact
4x switching relay, 2A, 250 V AC
1x triac relay, 2A, 250 V AC
1× conf., 2× 0–10V
EEPROM
-10°C to 55°C
-20°C to 85°C
10 to 90 % (non-condensing)
Depending on the sensor used
± 0,7 °C ±1 digit