Cable Specifications - Danfoss vlt series Operating Instructions Manual

General Specifications
EMC standards, Emission
EMC standards, Immunity
See section on special conditions in the VLT

5.4 Cable Specifications

Cable lengths and cross-sections
Maximum motor cable length, shielded/armored
Maximum motor cable length, unshielded/unarmored
Maximum cross-section to control terminals, flexible/rigid wire without cable end sleeves
5 5
Maximum cross-section to control terminals, flexible wire with cable end sleeves
Maximum cross-section to control terminals, flexible wire with cable end sleeves with collar
Minimum cross-section to control terminals
5.5 Control Input/output and Control Data
Digital inputs
Programmable digital inputs
Terminal number
Logic
Voltage level
Voltage level, logic 0 PNP
Voltage level, logic 1 PNP
Voltage level, logic 0 NPN
Voltage level, logic 1 NPN
Maximum voltage on input
Pulse frequency range
(Duty cycle) Minimum pulse width
Input resistance, R
Safe Torque Off terminal 37
Voltage level
Voltage level, logic 0 PNP
Voltage level, logic 1 PNP
Nominal input current at 24 V
Nominal input current at 20 V
Input capacitance
All digital inputs are galvanically isolated from the supply voltage (PELV) and other high voltage terminals.
1) Terminals 27 and 29 can also be programmed as output.
2) Except Safe Torque Off input terminal 37.
3) See chapter 2.3.1 Safe Torque Off (STO) for further information about terminal 37 and STO.
Analog inputs
Number of analog inputs
Terminal number
Modes
Mode select
Voltage mode
Voltage level
Input resistance, R
Maximum voltage
Current mode
Current level
Input resistance, R
Maximum current
72
VLT
®
AutomationDrive FC 301/FC 302 Design Guide.
2)
2)
i
3)
(terminal 37 is fixed PNP logic)
i
i
Danfoss A/S © 04/2016 All rights reserved.
®
AutomationDrive FC 302
EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6
EN 61800-3, EN 61000-6-3/4, EN 55011
EN 61800-3, EN 61000-6-1/2,
150 m (492 ft)
300 m (984 ft)
1.5 mm 2
2
1 mm
2
0.5 mm
2
0.25 mm
1)
18, 19, 27 , 29, 32, 33
PNP or NPN
0–24 V DC
>10 V DC
>19 V DC
<14 V DC
0–110 kHz
approximately 4 kΩ
0–24 V DC
>20 V DC
50 mA rms
60 mA rms
Voltage or current
Switch S201 and switch S202
Switch S201/switch S202 = OFF (U)
-10 V to +10 V (scaleable)
approximately 10 kΩ
Switch S201/switch S202 = ON (I)
0/4 to 20 mA (scaleable)
approximately 200 Ω
MG34Q402
/16 AWG
/18 AWG
/20 AWG
/24 AWG
4 (6)
<5 V DC
28 V DC
4.5 ms
<4 V DC
400 nF
2
53, 54
±20 V
30 mA