Panel Mounting - Nexcom IPPC 1560T Series User Manual

Chapter 3: System Setup

Panel Mounting

1. Select a place on the panel where you will mount the panel PC.
2. Cut out a shape on the panel that corresponds to the panel PC's rear
dimensions.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall,
etc.) where you will mount the Panel PC must not exceed 5mm for IPPC
1960T series, 4mm for IPPC 1560T series, and 12mm for IPPC 2160P. If
the distance between the front bezel and panel mount hole is too wide,
it will not fit the panel mount kit.
CUT DUT SIZE T=4MM(MAX)
IPPC 1560T Series
Suitable for mounting on the flat surface of Type 2 and Type
4X indoor use only enclosure.
Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved.
4.00 (Max.)
455.00
CUT DUT SIZE T=5MM(MAX)
98
455.00 5.00 (Max.)
IPPC 1960T Series
547.00
IPPC 2160P
IPPC 1560T/1960T/2160P Series and APPC 1560T User Manual
12.00
(Max.)