Remote Control, On/Off Button; Installing The Power Cord - Barco Medea series Installation Manual

Physical Installation
Image 4-5
Remarks when using the RC5 protocol
Due to new or updated functionality not all buttons of the Pulse RCU are one-to-one compatible with the
legacy Barco RCU and projectors. Take the following limitations into account:
• Buttons Shutter open and Shutter close emit the same code when in RC5 mode. This because the
legacy RCU's only had 1 button for Shutter functionality.
• Buttons Power on and Power off emit the same code when in RC5 mode. This because the legacy RCU's
only had 1 button for Power functionality.
• The RGB filter button is not supported.
• The Input selection button is not supported.
• The Default value button is not supported.
• The Macro button is not supported.

4.4 Remote control, on/off button

Purpose of the remote control on/off button
The Pulse remote control unit has at the front side an on/off switch (reference 1 Image 4-6). Switching off the
remote control prevents that unwanted commands are send due to an accidental key press. Furthermore,
switching the RCU off will extend the battery life time of the remote control.
To activate the remote control press the on/off button.
To deactivate the remote control press the on/off button again.
Default when (re)placing batteries, is "ON".
Image 4-6

4.5 Installing the power cord

CAUTION: Use only the power cord provided with the projector.
34 R5906141 /02 Medea series
1