Barco F70 Series User Manual page 123

Image 11-3
4. Enter the menu Home/Installation/3D Setup, and set the dark time to 1600us or 1850us depending on which
colorwheel installed.(The projector detect the color wheel, and only one option is available, depending on the
color wheel).
Image 11-4
5. Run a 3D image or movie from the source.
Put on the 3D goggles, and verify by looking through the goggles with one eye at the time that only one image
is visible in each eye. A double picture or a shade of the picture from the other side shall not be observed.
Repeat for both sides, and adjust the Sync Delay slider until a "clean" picture is visible in each eye.
If the 3D picture looks a bit "strange" through the 3D goggles, the solution is to swap eyes by enabling the
Swap eyes button in the menu.
3D
601–426-03 F70 Series 123