Regal LS4C Owner's Manual page 77

Using Chemical Toilet
Refer to the parts description and action #'s one page
back. Note to ensure the pressure in the holding tank
is equalized before usage. If needed, review earlier
pages and carry out action #2.
1. Remove flush water tank cap and fill the tank
with fresh water until level is 1" below the top.
Tighten the cap on flush water tank. Refer to action
#3.
2. Pull the flush grip to open the slide valve. Refer
to action #4.
3. Pour the recommended sanitation chemical
directly into the holding tank. Close the slide valve.
Refer to action #5.
4. Press the pump approximately 15 times or until
air exits the cap of the flush water tank through the
pressure relief valve. Refer to action #6.
This completes the initial toilet set-up. Follow the
up-coming instructions on flushing the portable toilet
and emptying the holding tank.
NOTICE
TO PREVENT HOLDING TANK DAMAGE DUE
TO FREEZING IN COLD CLIMATES IT IS
RECOMMENDED
TO DRAIN HOLDING TANK.
READ MANUAL FOR SPECIFIC INFORMATION.
Flushing Toilet
Follow the action #'s on the following page.
1. Pull out the flush grip to permit the waste to
pass into the holding tank. Refer to action #8.
2. Press the flush button to flush the toilet. Push
the flush grip to close the slide valve. Refer to
action #9.
Emptying Toilet (W/O Optional Pump-Out Fittings)
Note that if your toilet includes the pump-out fittings
by pass the steps below and have your tank pumped
out by an appropriate service company or marina.
1. When the filling display shows full the holding
tank needs to be emptied. Pull the locking grip on
the holding tank. To reach the aft bracket lift up the
toilet and move it. Refer to action #10.
2. Pull up on the aft latch to disconnect the flush
water tank from the holding tank. Refer to action
#11.
3. Take the holding tank to a reliable disposal
station or a normal toilet.
4. Turn the waste pipe away from the tank and
open the pressure relief valve on top of the tank.
Empty the tank. Refer to action #12.
5. After emptying holding tank rinse unit out with
fresh water using a garden hose if available.
6. Reassemble unit and fill with water and chemical.
77