Regal LS4C Owner's Manual page 121

Bimini Top (Typical)- PowerTower (Continued)
USE THE DIAGRAMS AND FOLLOW THESE
STEPS TO INSTALL THE BIMINI TOP:
1. Find jaw between pins on bottom of port forward
bow. Move sliding jaw over the top pin to release
the forward bow and pull up to upper set of pins
allowing the jaws to slide over the bottom pin and
locking in between the pins (yellow arrow). See
figure B. Do the same with the starboard forward
bow.
2. Find one of the straight eyed arms as shown in
Figure B. Turn the white chafing block in a direction
so its flat surface is between the straight arm and
the PowerTower to protect it. While pushing down
on the starboard forward bow align the straight
arm with the forward end of the jaw and install the
ball end of the straight arm into the front of the jaw.
Install a lanyard pin which will lock it in place. Do
the same with the other straight arm.
3. Locate the 90 degree aft arms. There are 2 each
for the aft bows. See Figure B. Start with either
side. Pull down on the aft top and insert the top arm
into the top jaw. Lock the arm in place by inserting
a lanyard pin. Repeat the same process with the
lower 90 degree arm. Follow the same procedure
with the 90 degree arms on the other side.
4. Note that the forward bow utilizes a strap and
latch similar to the latch on the boot. This strap
assists in holding the bimini top down as the vessel
is making forward headway. Attach the upper and
lower strap together and attach at the camel-back.
5. Perform the steps in reverse order to disassemble
the bimini top. The sliding jaw on the forward bow
will need to be pushed down to the lower set of
pins on the forward bow on both sides for the top
to set in the proper place. Use the arm retainer
blocks to latch the arms in place. Reinstall bimini
top in boot and zip it up.
6. Be sure to read the canvas manufacturer's
information regarding caring for your canvas which
can be found in the owner's information bag or visit
their web-site.
Remember not to exceed 35 mph with the bimini
top up on the waterways.
NOTICE
CHECK YOUR STATE LAWS AND
REGULATIONS BEFORE ATTEMPTING
TO TOW THIS VESSEL. SPECIAL PERMITS
AND EQUIPMENT MAY BE NEEDED.
FOR HIGHWAY TOWING THE POWERTOWER
SHALL BE IN THE COMPLETE FORWARD
POSITION AND ALL CANVAS SHALL BE IN
THEIR DEDICATED BOOTS.
ALL ATTACHED CANVAS BOW HARDWARE
SHALL BE CHECKED FOR TIGHTNESS
BEFORE AND AFTER TOWING.
CARPET/MATING SHALL BE ROLLED UP AND
STORED IN A DEDICATED LOCKER.
121