Regal LS4C Owner's Manual page 116

Canvas TYPICAL COCKPIT COVER
There are canvas options available for your vessel
including cockpit covers, PowerTower and travel/
storage covers. Let us look at the basic installation
on each type. As general information many of our
models use Sunbrella a solution dyed fabric well
known for its ability to hold up in the harsh marine
environment.
Cockpit Cover
If installed, the cockpit cover normally installs over
the windshield and snaps to the deck. The cockpit
cover is meant to protect the cockpit of the boat
from weather elements. The cockpit cover is not to
be used for towing purposes.
Ensure the center windshield is in the closed
position. Start snapping the cover to the deck by
use of the eyelet snaps, starting at the bow and
working aft. Continue snapping the cockpit cover
to the deck snaps. When you reach the rear corner,
leave enough room for an exit point. Notice in the
middle underside of your cover, you may find an
area of reinforced canvas with an eyelet snap. This
snap connects to a cockpit cover pole. This pole
is adjustable, and by opening the lock, the pole
can telescope out to the desired length. This pole
should push the canvas up when standing straight
up on its rubber enclosed foot. Again, the purpose
is to shed water off of the top.
The cockpit cover should be rolled up for storage
inside the ski locker when towing or storing your
boat. This canvas should not be used while the
engines are running.
116