Regal LS4C Owner's Manual page 130

Ladder-Exiting/Re-boarding
HAND HOLD
LADDER
The stern ladder is located under the port side of the
swim platform. It is the recommended component
for exiting or reboarding the vessel to and from the
water. Be sure to use the hand hold for support as
needed when using the ladder.
When not using ladder be sure to keep the ladder
locked in the framework as shown in top right photo.
Insist that only one person use the ladder at a time.
Periodically check the ladder hardware for tightness
and corrosion. Replace fasteners and lubricate
hinges as needed.
See the cosmetic care chapter regarding cleaning
and preserving the stainless steel. Read and un-
derstand all warning and information labels found
in the vicinity of the ladder.
To use the stern ladder grasp the ladder rung and
push the ladder up and in until the ladder round
pawls clear the spring loaded scalloped lock on
the framework. Pull the ladder out to the end of
the travel. Then flip the ladder over and let it down
gently. Make sure you keep all body parts clear of
any moving ladder parts especially the hinged top.
When reattaching pull the ladder up to retract the
rungs. Then grasp the rung and push it into the
scalloped lock and pull it down until the round pawl
is secured. Note that some resistance may be felt
during both the releasing and attaching process as
the ladder framework is spring loaded to complete
the locking process.
PAWL SCALLOPED LOCK
130