Regal LS4C Owner's Manual page 62

Battery Management Panel (Continued)
7
4. The ground block is a home for a group of neg-
ative (black) wires. You may even find an earth
ground on the block (green). This may be an ad-
ditional ground area for added accessories. Peri-
odically check to ensure all wires are fastened se-
8
curely. When adding accessories never add more
than 4 connectors to any stud on a ground block.
5. This bank provides a junction for wiring from the
battery charger circuits and from the ACR unit.
Periodically check wires for secure fastening.
6. Battery switch (rear view). See earlier informa-
tion for additional details. Note the red boots on
PUSH SIDE BUTTON TO RESET BREAKER
the rear of the battery switch. Periodically check to
ensure the boots cover the nuts securely and that
the connections and nuts are tight. Disconnect the
battery (ies) positive (+) wires before tightening
the battery switch nuts.
7. Overboard discharge breaker. Installed as part
of optional equipment to protect the overboard
discharge motor and wire circuitry. If the breaker
pops push button on side of breaker to reset. Al-
ways figure out the cause of the overload before
resetting the breaker.
8. Electric head breaker. Installed as part of op-
tional equipment to protect the Tecma electric
head motor and wire circuitry. If the breaker pops
push button on side of breaker to reset. Always
figure out the cause of the overload before reset-
ting the breaker.
62