Regal LS4C Owner's Manual page 118

Bimini Top (Typical)- PowerTower (Continued)
The first step in using the typical bimini top is to
remove top from the boot. Push both sides of the
latch inward simultaneously (green area) and pull
on the ends of the latch to open it. Find the boot
zippers in the forward center section of the top.
Unzip the boot and remove it from the bimini top.
Store it in a dry locker for later reinstallation. See
the photo above.
Once the boot is removed note there is an alignment
snap in both the forward and aft center top bow.
Always make sure these snaps are buttoned down
or it may become difficult to install the top arms
due to misalignment (bimini top not in the center of
the forward and/or aft bow). See the photo above.
118