Setting Up Network Operation - Extron electronics USB Extender Plus Series User Manual

Setting Up Network Operation

To set up the USB Extender Plus for use on the network, do the following:
1. Connect the transmitter, receivers, and computer to a gigabit network switch (see
figure 12
NOTE: The transmitter, receivers, and the PC running the PCS software must all be
on the same subnet and network.
2. By default, over-the-network pairing should be enabled. If it is not, enter the following
SIS command to enable it:
E
N 1 USBC
(See SIS Commands
3. Obtain the subnet mask and gateway IP address of your computer network. Either
obtain this information from your system administrator, or via a Windows Command
window as follows:
a. Open a
b. At the command prompt enter
figure 23 appears, displaying connection information for the computer.
NOTE: Before assigning network addresses, check with your system administrator
to find out what IP addresses are available or appropriate for you to use.
4. Record the
Figure 23.
5. Use the PCS configuration software or SIS commands to set the IP address, gateway
address, and subnet mask as needed (see
on page 15 for an example).
}
on page 22 for information on entering these commands.)
window on your computer.
Command
ipconfig
and
Subnet Mask Default Gateway
Command Prompt Window with IP Information
USB Extender Plus Series • Remote Configuration and Control
. A screen similar to the example in
addresses (see figure 23,
figure 27 on page 32).
).
1
29