Receiver Rear Panels - Usb Extender Plus R, Standard And Hid-Only - Extron electronics USB Extender Plus Series User Manual

Receiver Rear Panels — USB Extender Plus R, Standard and HID-only
POWER
12V
1.0A MAX
A A
Power connector
A
Twisted Pair Input connector
C
USB hub connectors
D
Figure 5.
Power connector — Connect a provided 12 VDC, 1 A max. external power supply to
A
this 2-pole, 3.5 mm captive screw connector.
ATTENTION:
•
•
Host (input) connector — Connect a USB type A to B cable between this USB type
B
B port and the USB port of a host. The USB Extender Plus is USB 3.0 compliant and
supports data transfers of 480 Mbps (high speed), 12 Mbps (full speed), and 1.5 Mbps
(low speed).
Twisted pair connector —
C
NOTES:
•
•
Transmitter — Connect a TP cable from the RJ-45 Input connector of the receiver
•
(see figure 5,
Receiver — Connect a TP cable from the RJ-45 Output connector of the
•
transmitter to this connector.
See Twisted Pair Cable Termination
necessary.
USB Hub connectors — The built-in four port hub has four female USB Type A
D
connectors. The connections are USB 3.0 compatible, providing +5 VDC at up to
500 mA to connected USB peripherals requiring power.
C C
Receiver Rear Panel Connectors (Rack Mountable Models)
Before connecting power, be sure to read the
Notices on page 9.
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les
en garde sur la page 9.
On the transmitters, the RJ-45 connector is the output port.
On the receivers, the RJ-45 connector is the input port.
) to this female RJ-45 connector.
C
USB Extender Plus Series • Installation and Operation
1 3
2 4
D D
Power Supply Attention
on page 37 to wire the RJ-45 connectors if
mises
6