Table of Contents
Advertisement
Mounting USB Extenders Plus AAP and D
You can install the USB Extender Plus AAP and decorator-style transmitter and receiver in
an electrical junction box, attach them to AAP frames or mud rings, or both.
Wall mounting
Safety guidelines
The wall installation must conform to national and local electrical codes and to the wall
plate size requirements. The following UL guidelines pertain to the installation of the wall
mountable transmitters and receivers into a wall or furniture.
•
Do not connect these units to a centralized DC power source or use beyond their rated
voltage range.
•
These units must be installed in UL Listed junction boxes.
•
These units must be installed with conduit in accordance with National Electrical Code.
Preparing the site and installing the junction box
If installing the extender in a junction box:
•
Choose a location that allows cable runs without interference.
•
Allow enough depth for the wall box, the TP cable, and power supply wiring. The box
should be at least 2.5 inches (6.4 cm) deep to accommodate the connectors and
cables.
Figure 35.
•
Run the TP and power supply wires into the wall, furniture, or conduits before installing
the wall plate.
•
Follow the instructions provided with the junction box to install it.
NOTE: The Decorator-Style series mounts in a standard single-gang junction box.
2.5"
(6.4 cm)
1.6"
(4.1 cm)
Wall Box Depth Profile — AAP and Decorator-Style
USB Extender Plus Series • Reference Information
39
Advertisement
Table of Contents
