Extron electronics USB Extender Plus Series User Manual page 34

ASCII Command
Command
(Host to Unit)
Network Settings
E X!
Set DHCP mode
E
Set IP address E X@
View IP address E
E X$
Set subnet mask
E
View subnet mask
Set gateway IP address E X%
View gateway address E
Set Config port map E
NOTES:
•
Duplicate port number assignments are not permitted (for example, the Telnet and web port numbers cannot be the
same). If this is attempted, an E13 error code is returned.
•
Remapping of a port number (other than to reset it to the default 06137 or disable it by resetting it to 0) must be to
port numbers higher than 1024.
Reset Config port map E
E
Disable Config port
View Config port map E
Response
(Unit to Host)
}
DH Idh
} X! ]
DH
}
CI Ipi
} X@ ]
CI
}
CS Ips
} X$ ]
CS
}
CG Ipg
} X% ]
CG
X^ }
K PMAP Pmap K
}
K 06137 PMAP Pmap K 06137
}
K 0 PMAP Pmap K 00000
} X^ ]
K PMAP
USB Extender Plus Series • Remote Configuration and Control
Additional Description
X! ]
Enable or disable Dynamic Host
Configuration Protocol (DHCP) automatic
assignment of IP addresses. For
0 = DHCP disabled (default)
1 = DHCP enabled
Show current DHCP status
• X@ ]
Set IP address
Default: 192.168.254.254
Show the current unit IP address.
• X$ ]
Set subnet mask
Default: 255.255.0.0
Show the current subnet mask for the unit.
• X% ]
Set gateway address
Default: 0.0.0.0
Show current gateway address of the unit.
X^ ]
Set a port number (
Default: 06137
] Reset the Config port number to the
factory default (06137).
]
Disable the Config port.
View the current Config port number.
X!
:
X!
.
X@
for the unit.
.
X$
for the unit.
.
X%
for the unit.
X^
) for the Config port.
26