Changing Wheels - Suzuki Ciaz Owner's Manual

NOTICE
Never apply a garage jack to the
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
NOTE:
For more details, please contact an autho-
rised Maruti Suzuki workshop.

Changing Wheels

To change a wheel, use the following pro-
cedure:
1) Clear all passengers and luggage from
the vehicle.
2) Remove the jack, tools and spare
wheel from the vehicle.
3) Loosen, but do not remove the wheel
nuts.
4) Jack up the vehicle.
5) Remove the wheel nuts and wheel.
6) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel and hub with a clean cloth.
Clean the hub carefully; it may be hot
from driving.
7) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
EMERGENCY SERVICE
EXAMPLE
Loosen
Tighten
Tightening torque for wheel nut
100 Nm (10.2 kg-m, 73.8 lb-ft)
8) Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
WARNING
Use Maruti genuine wheel nuts and
tighten them to the specified torque
as soon as possible after changing
wheels. Incorrect wheel nuts or
improperly tightened wheel nuts may
come loose or fall off, which can
result in an accident. If you do not
have a torque wrench, have the wheel
nut torque checked by an authorised
Maruti Suzuki workshop.
79MH0-74E
54G116
8-4