Taylor-Dunn SS-025-34 Service And Parts Manual page 42

Steering
STEERING GEAR, SS-536, SS-546, MX-600
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Remove the steering gear from the vehicle.
2: Remove the steering wheel.
3: Remove the cover bolts.
4: Remove the cover and discard the gasket.
Note: The stem and gear may come off with the cover.
5: Remove as much grease as possible from the inside of the gear box.
6: Remove the gear case and clean the remaining grease from the bottom of the
gear box.
7: If the stem and gear did not come out with the top cover, remove it now.
8: Remove and discard the lower gasket.
9: Thoroughly clean all parts.
10: Reassemble in reverse order installing new gaskets.
• Check the bronze bushings for wear and replace them as needed.
• Apply grease to all gears.
Page 42
SS and MX Models, DC System
MS-534-13