Tool List - Taylor-Dunn SS-025-34 Service And Parts Manual

Tool List

TOOL LIST
The tools shown here are generic for
servicing Taylor-Dunn vehicles. Not all tools
will be required for servicing this vehicle.
41-532-50: Chain Case Centering Tool
Used to center the chain case cover on all
vehicles equipped with the Power Traction
primary reduction and a pinion brake or speed
sensor. Includes instructions.
62-027-61 and -62: Sevcon System
Handset
Diagnostics and adjustments (-62 only)
of the Sevcon Power Pak and Micro Pak
control systems.
Page 20
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
43-201-50: Pinion Seal Installation Tool
Used to install the pinion seal on all vehicles
equipped with the Power Traction primary
reduction and a pinion brake or speed
sensor.
Controller Programming:
Sevcon: 62-027-63 "PCpaK Cable lead and application."
Curtis AC: 62-027-66 "1314 PC Programming Station"
SS and MX Models, DC System
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
Curtis AC System Handset. Diagnostics and
adjustments of the Curtis AC control system.
62-027-67: Diagnostics and adjustments
62-027-68: Diagnostics only
MS-534-13