Front Axle; Replace Front Wheel Bearings (3-Wheel); Replace Front Wheel Bearings (4-Wheel) - Taylor-Dunn SS-025-34 Service And Parts Manual

Front Axle

REPLACE FRONT WHEEL
BEARINGS (3-WHEEL)
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Set the park brake.
2: Disconnect the batteries.
3: Raise the front of the vehicle and support with
jack stands.
4: Remove the tire/wheel assembly from the fork.
Refer to Axle Shaft section.
5: Thoroughly clean all grease from the inside of the
hub and the bearings.
6: Inspect and replace the races and bearings as a
set.
7: Assemble in reverse order, using new grease
seals.
8: Reinstall the tire/wheel. Refer to Axle Shaft
section.
a. Pack the bearings with grease.
b. Adjust the bearing preload per specifications in
the Adjust Front Wheel Bearing procedure.
9: Lower the vehicle.
10: Reconnect the batteries.
11: Remove the blocks from behind the wheels.
12: Release the park brake and test drive.
Page 34
SS and MX Models, DC System
REPLACE FRONT WHEEL
BEARINGS (4-WHEEL)
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Set the park brake.
2: Disconnect the batteries.
3: Raise the front of the vehicle and support with
jack stands.
4: Remove the tire/wheel assembly from the hub.
Refer to the Tire/Wheel section for information
regarding removing the tire/wheel assembly.
5: Remove the hub dust cap, cotter pin, and spindle
nut.
6: Remove the hub from the steering knuckle.
7: Thoroughly clean all grease from the inside of the
hub and the bearings.
8: Inspect and replace the races and bearings as a
set.
Note: It is recommended to replace all four
bearings and races in the left and right
wheels as a set.
9: Assemble in reverse order, using new grease
seals.
a. Pack inner and outer bearings with grease.
b. Adjust the bearing preload per specifications in
the Adjust Front Wheel Bearing procedure.
d. Install a new cotter pin.
10: Install the hub dust cap.
11: Reinstall the tire/wheel. Refer to the Tire/Wheel
section for information regarding installing the
tire/wheel assembly
12: Lower the vehicle.
13: Reconnect the batteries.
14: Remove the blocks from behind the wheels.
15: Release the park brake and test drive.
MS-534-13