Ardf (D630) - Ricoh D143 Field Service Manual

Important: Use the procedure below to do the output checks for the fusing exit motor. If
you do not follow this procedure, a kink will form in the fusing belt sleeve, and the fusing
sleeve belt unit will need to be replaced.
1. Do one of the following:
• Open the right cover of the paper bank
• Remove one of the toner bottles
• Pull out the waste toner bottle half-way
• Remove the fusing unit
2. Enter SP mode.
3. Do the following out output checks:
• SP5-804-031 (Fusing exit motor: High speed)
• SP5-804-032 (Fusing exit motor: Middle speed)
• SP5-804-033 (Fusing exit motor: Low speed)
• SP5-804-035 (Fusing exit motor: Very low speed)
4. Without exiting SP mode, turn the main power switch off and then on again.
Important: If you exit SP mode before you turn the main power switch off, the fusing exit
motor will stay off when the machine warms up. Heat will be concentrated in one area
of the fusing belt sleeve and cause a kink to form. If this happens, you will need to
replace the fusing sleeve belt unit.
5. Do the reverse of what you did in step 1 (for example, reattach the fusing unit).
5804 31 Fusing Exit Motor: HighSpeed
5804 32 Fusing Exit Motor: MiddleSpeed
5804 33 Fusing Exit Motor: LowSpeed
5804 35 Fusing Exit Motor: LLowSpeed

ARDF (D630)

6008
6008 1 Pick-Up Motor Forward
6008 2 Pick-Up Motor Reverse
6008 3 Feed Motor Forward
6008 4 Feed Motor Reverse
Display
Fusing/Paper Exit Motor: High Speed
Fusing/Paper Exit Motor: Middle Speed
Fusing/Paper Exit Motor: Low Speed
Fusing/Paper Exit Motor: LLow Speed
Description
-
-
Feed Motor-Forward rotation
Feed Motor-Reverse rotation
Input and Output Check
393