Contents and general instructions
Notes on the use of this manual
Support of
MPA1 pneumatic and handheld
type CPX−MMI−1
MPA2 pneumatics
CPX−CP interface
CPX−FB11
As Remote Controller
(e.g. with CPX−FEC)
Modular EDS
1)
Software status (SW) or revision no. (R) see type plate
Tab. 0/1:
Support of features and software status
Festo P.BE−CPX−FB11−EN en 0503b
Please note
This manual refers to the following versions:
Field bus node CPX−FB11
as from software status 26.05.03 (R09)
as from software status 26.05.03 (R09)
as from software status 12.10.05 (R16)
as from software status 25.04.05 (R14)
as from software status 12.10.05 (R16)
This manual contains specific information on installation,
commissioning, programming and diagnosis with the CPX
field bus node for DeviceNet.
General basic information on the method of operation, on
fitting, installing and commissioning CPX terminals can be
found in the CPX system manual.
Information on further CPX modules can be found in the
manual for the relevant module.
1)
EDS file
as from Rev. 1.3
as from Rev. 1.3
as from Rev. 2.1
(Modular EDS)
as from Rev. 2.1
XI