Charging The Battery Pack; Replacing The Battery Pack - Advantech-DLoG DLT-V72 Series Manual

Optional equipment
12.1.2.

Charging the battery pack


Connect the properly installed DLT-V72 to the main supply voltage.
ATTENTION:
The cable cover of the DLT-V72 must be screwed together properly.
The battery pocket must be screwed together properly.
The device must be fully closed.
Electric shock when charging the battery pack.

Do not connect damaged battery packs to the DLT-V72; do not charge.

Battery packs become warm while charging; this is normal. However, if they become
excessively hot, immediately disconnect the DLT-V72 from the power source.

Do not continue to use the DLT-V72 if you notice an unusual level of heat or an unusual
smell during charging.

Provide for sufficient ventilation of the DLT-V72 during charging.
12.1.3.

Replacing the battery pack

The battery pack of the DLT-V72 can be charged approx. 600 times.
It may only be replaced by an original battery pack from Advantech-DLoG.
Personal injury due to short-circuit, fire, chemical burns, toxic substances.
No third-party battery packs permitted.




Advantech-DLoG
WARNING
WARNING
Use only original battery packs from Advantech-DLoG.
The battery packs must be authorized/approved for the DLT-V72.
Do not use battery packs from any other Advantech-DLoG devices; they are not
compatible.
If battery packs from other manufacturers are inserted in the DLT-V72, the warranty
provided by DLoG GmbH for this device will be rendered void.
DLT-V72 Series Manual V2.00 69 / 94