Error Messages - Ricoh Aficio MP C305SP Field Service Manual

5. System Maintenance
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure the SD
card locks in place.
• To remove the SD, push it in to unlock the spring lock. Then release it so it pops out of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update screen
appears on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the operation panel to
select the item in the menu that you want to update.
ROM/NEW
ROM:
NEW:
• Controller, engine and operation panel firmware cannot be updated at the same time. It is
recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or
• The progress bar does not show for the operation panel firmware after you touch "OpPanel".
The power on key flashes on and off at 0.5 s intervals when the LCDC firmware is updating.
The power key flashes on and off at 3 s intervals when the update is finished.
9. The "Update is Done" message appears on the operation panel after completing the updating. The
message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or follow the
procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.

Error Messages

An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows error "E24" displayed.
For details, refer to the Error Message Table (see "Handling Firmware Update Error").
604
Tells you the number of the module and name of the version currently
installed. The first line is the module number, the second line the version
name.
Tells you the number of the module and name version on the SD card. The
first line is the module number, the second line the version name.
) to start the update.
What it means