Ricoh Aficio MP C305SP Field Service Manual page 356

5. System Maintenance
002 Mode b
003 Mode c
004 Mode d
[TM/ID Sensor Test]
2112
This SP is used to check the ID sensors at the factory. The results of this SP are displayed in
SP2140 to SP2145.
001 TM/ID Sensor Check
010 General:FCRP
020 Threshold Setting
[Skew Adjustment]
2117
Specifies a skew adjustment value for the skew motor M, C, Y or Bk.
001 Ma:Skew Adjustment
002 Cy:Skew Adjustment
003 Ye:Skew Adjustment
004 Bk:Skew Adjustment
354
[Execute]
Executes the fine line position adjustment
once.
ENG
If this SP is not completed, do
SP2111-003 first and then try this SP
again
[Execute]
Executes the rough line position adjustment
once.
ENG
After doing this SP, make sure to execute
SP2111-001 or -002. Otherwise, the line
position adjustment is not perfectly done.
[Execute]
ENG
Executes the fine line position adjustment
and rough line position adjustment.
*ENG [Execute]
*ENG [0 to 9999 / - / 1/step]
*ENG [0.00 to 5.50 / 1.90 / 0.01V/step]
*ENG
*ENG
[–256 to 256 / 0 / 1 click/step]
*ENG
*ENG