Table of Contents
Advertisement
For the KBox A-150-APL with Wi-Fi, the front panel keep out area depends on the implemented dual Wi-Fi antennas
and the orientation of the Wi-Fi antennas.
Figure 24: Keep Out Area for installed dual Wi-Fi Antenna (with external 2.5" HDD/SSD drive bay)
Wi-Fi antennas require an additional keep out area. Kontron's reference Wi-Fi antennas
require a minimum of 40 mm horizontally and 135 mm in required antenna direction when
measured from the Wi-Fi connector.
Wiring the Mating Power Connector/Terminal
The DC input power connector connects to a DC power supply using the supplied mating power connector/terminal
(PSC 1.5/ 3-F) and the corresponding wiring. The wiring is inserted into the mating power connector/terminal's
clamps, see Figure 25, pos. 4, 5 & 6 and must be clearly marked (+/-/functional earth) to ensure proper connection to
the DC power supply.
The wiring is not part of the delivery und must be provided by the user.
Use copper conductors only if the field wiring terminal is only for connection to copper wire.
Minimum temperature rating of the cables connected to the field wiring terminals is 75° C.
Figure 25: Input Power Connector and Mating Power Connector/Terminal
1
1
3-pin input power connector (PSC 1,5/ 3-M)
2 3-pin mating power connector/terminal
(PSC 1,5/ 3-F)
3 Cover over the slotted pan head screws
www.kontron.com
135 mm
40 mm
KBox A-150-APL - User Guide, Rev. 1.6
5
4
6
4 Clamp for functional earth wire
5 Clamp for 0 VDC wire
6 Clamp for +24 VDC wire
2
3
// 38
Advertisement
Table of Contents
