Nexcom NIFE 103 User Manual page 55

Chapter 4: BIOS Setup
Restore AC Power Loss
Power Off When power returns after an AC power failure, the system's
power is off. You must press the power button to power-on
the system.
Power On When power returns after an AC power failure, the system
will automatically power-on.
Last State When power returns after an AC power failure, the system
will return to the state where you left off before power
failure occurs. If the system's power is off when AC power
failure occurs, it will remain off when power returns. If the
system's power is on when AC power failure occurs, the
system will power-on when power returns.
Copyright © 2017 NEXCOM International Co., Ltd. All Rights Reserved.
USB Configuration
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Chipset
USB Configuration
XHCI Mode
USB 2.0(EHCI) Support
USB RMH Mode
USB EHCI debug
USB Power State in S5
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
USB 2.0(EHCI) Support
Enables or disables the Enhanced Host Controller Interface (USB 2.0), one
EHCI controller must always be enabled.
USB RMH Mode
Enables or disables PCH USB rate matching hubs mode.
USB EHCI Debug
Enables or disables PCH EHCI debug capability.
USB Power State in S5
Configures the USB power state in S5.
41
Control the USB EHCI
(USB 2.0) functions.
[Disabled]
One EHCI controller
must always be enabled.
[Enabled]
[Enabled]
[Disabled]
[Power On]
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NIFE 103 User Manual