Nexcom NIFE 103 User Manual page 50

Chapter 4: BIOS Setup
PPM Configuration
This section is used to configure the Processor Power Management (PPM)
configuration.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Advanced
PPM Configuration
EIST [Disabled]
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
EIST
Enables or disables Intel ® SpeedStep.
Copyright © 2017 NEXCOM International Co., Ltd. All Rights Reserved.
IDE Configuration
This section is used to configure the SATA drives.
Enable/Disable Intel SpeedStep
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Serial-ATA (SATA)
Enables or disables SATA device.
SATA Mode
Configures the SATA as AHCI mode.
Serial-ATA Port 0 and Serial-ATA Port 1
Enables or disables SATA port 0 and SATA port 1.
SATA Port1 Hotplug and SATA Port2 Hotplug
Enables or disables hotplug support on SATA port 1 and SATA port 2.
36
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Advanced
IDE Configuration
Serial-ATA (SATA) [Enabled]
SATA Mode [AHCI Mode]
Serial-ATA Port 0 [Enabled]
[Disabled]
SATA Port0 HotPlug
Serial-ATA Port 1 [Enabled]
SATA Port1 HotPlug [Disabled]
SATA Port0
Not Present
SATA Port1
Not Present
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Enable / Disable Serial ATA
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NIFE 103 User Manual