Selecting The Spray Setting (Wall Extra I-Spray Spray Attachment); Selecting The Spray Setting (Standard Spray Attachment); Adjusting The Material Volume (Wall Extra I-Spray Spray Attachment) - WAGNER W 600 FLEXIO 18V Manual

W 600 Flexio 18V
11. Selecting the Spray Setting
(Wall Extra I-Spray spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the air cap (fig. 5, 1)
Tighten the union nut (Fig. 5, 2) fully so that no paint is able to penetrate
the device. Check regularly whether the union nut has worked loose during
operation.
Fig. 6 A = vertical flat jet
Fig. 6 B = horizontal flat jet 
Use the red adjustment lever to also switch between a wide
( ) and a narrow (
12. Selecting the Spray Setting
(Standard spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 7, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 8 A = vertical flat jet
Fig. 8 B = horizontal flat jet 
Fig. 8 C = circular jet
13. Adjusting the Material Volume
(Wall Extra I-Spray spray attachment)
The volume of material can be set by turning the material volume control (Fig. 9, 1) in
steps from 1 (minimum) to 12 (maximum).
for horizontal surfaces

for vertical surfaces
) spray jet.
for horizontal surfaces

for vertical surfaces
for corners, edges and hard-to-reach surfaces

EN
33