Table of Contents
Advertisement
58
System Operation
the description of TEC:CONST command for further details on these
constants.
To modify these constants, use the UP and DOWN arrow keys to select this
menu item. Press the SETUP/ENTER key to enter a sub-menu for this item.
A sample sub-menu for setting the sensor constants is shown in figure below.
The contents of this screen will vary depending upon the sensor selected.
Use the UP and DOWN arrow keys to select the sensor constant that needs to
be modified. Once the desired item has been selected, press the
SETUP/ENTER key to change the item's state from idle to active. Once the
item is in active state, the leading digit begins flashing. Use the cursor keys to
specify a desired value. Once the desired value has been selected, press
SETUP/ENTER key to accept the new value. The new sensor constant will
take effect immediately, and the menu item will be returned to idle state.
Press Esc key to cancel any changes or to return to Set Sensor Constants main
menu.
It is highly recommended that the output be turned OFF before the gains are
customized.
4.4.9.3
Set System Params Menu
The Set System Params menu item is used to change display brightness, lock
the dial on the front panel, turn beeper ON/OFF, USB address, and to
save/recall system settings
To modify these constants, use the UP and DOWN arrow keys to select this
menu item. Press the SETUP/ENTER key to enter a sub-menu for this item.
A sample sub-menu for setting the system parameters is shown in figure
below.
C1 =
1.129
C2 =
2.341
C3 =
0.877
Figure 26
A Sample Sensor Constants Sub-menu
Brightness = 100%
Lock Dial
Aud. Beep
USB Address=
=
No
=
Yes
1
Advertisement
Table of Contents
