Adding A San Clients Group; Deleting A San Client Group - Quantum DXi V-Series Manual

Adding a SAN Clients
Group
Deleting a SAN Client
Group
VTL Configuration CLI Commands
serial = VL01SV0825BVA04501
lun = 1
[device = 2]
type = VTD
serial = VL01SV0825BVA04501
lun = 2
syscli --add sanclientgroup --name <VTL_name> --groupname
<group_name> --wwpn <world_wide_port_name> --target <target>
(--device <device_serial_number> --lun <desired_LUN>) [ --useccl ]
This CLI command allows the CLI admin to add a host access group. The
following are required to create a host access group.
• Group Name
• VTL Name
• Host Name or WWPN
• Target (FC Port)
• List of device serial numbers (either VMC or VTD) and the desired host LUNs.
There should at least be one device and LUN specified.
The WWPN can be derived from the values returned for wwpn field name of the
list of host CLI. The Target can be derived from the value returned for wwpn
field name of the list of targets CLI. The List of device serial number can be
derived from the 'serial' field name of the list of devices of the VTL specified.
If the --useccl option is specified, the Command and Control LUN feature is
enabled.
Note: The CCL (Command and Control LUN) is not used in most
environments. This option is recommended for host access groups that
contain an HP-UX host. It can also be used if hosts that are not
assigned to any host access group exist in the SAN. The CCL is
accessible to hosts only through LUN 0.
Caution: If you are not sure if you should use CCL, contact Quantum
Customer Support before you enable this option.
syscli --del sanclientgroup --name <VTL_name> --groupname
<group_name>
This CLI command allows the CLI admin to delete a SAN client group given the
required VTL name and the group name.
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
19