Adding A San Clients Group - Quantum DXi2500-D Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
Adding a SAN Clients
Group
20
An example output of a SAN client group is shown below.
group count = 1
group = 1
vtl name = MyVTL
group name = Group1
host =
target =
device count = 2
device = 1
type = VMC
serial = VL01SV0825BVA04501
lun = 1
device = 2
type = VTD
serial = VL01SV0825BVA04501
lun = 2
end
syscli --add sanclientgroup --name <VTL_name> --groupname
<group_name> --wwpn <world_wide_port_name> --target <target>
(--device <device_serial_number> --lun <desired_LUN>) [ --useccl ]
This CLI command allows the CLI admin to add a host access group. The
following are required to create a host access group.
• Group Name
• VTL Name
• Host Name or WWPN
• Target (FC Port)
• List of device serial numbers (either VMC or VTD) and the desired host LUNs.
There should at least be one device and LUN specified.
The WWPN can be derived from the values returned for wwpn field name of the
list of host CLI. The Target can be derived from the value returned for wwpn
field name of the list of targets CLI. The List of device serial number can be
derived from the 'serial' field name of the list of devices of the VTL specified.
If the --useccl option is specified, the Command and Control LUN feature is
enabled.
VTL Configuration CLI Commands