Quantum DXi V-Series Manual page 17

CLI Exit Code
Web Services Support (Optional)
CLI Exit Code
• The third password has five characters: a, \, !, b, and c.
• The fourth password has five characters: ", a, b, c, and ".
If the command runs to completion successfully, it returns an exit code of zero
(0) along with the following message:
Command completed successfully.
If the command fails, it returns an exit code of one (1) along with a one line
error message that summarizes the error. This error message is always prefixed
with " " and appended with an error code in parentheses. For example:
ERROR:
syscli ‐‐add share ‐‐proto cifs ‐‐name cifs1 ‐‐desc "For
testing only"
......
ERROR: CIFS server is disabled! (E1000011)
It can be seen that the error code is "E1000011" and the error message is "
server is disabled!
Note: Possible error codes are listed at the end of each major section below.
Note: The Web services options, --ws, have been deprecated and are
disabled.
By default, each CLI is executed directly on the DXi system it is running.
However, it is possible to send the command to another DXi system for
execution and display the result on the local DXi system. The syscli program in
DXi 2.x Software has the capability of running the command remotely using
Web Services WSDL protocol version 2.0, provided that the remote DXi system is
also running DXi 2.x Software as well.
Starting with DXi 2.0 Software, every DXi system runs a Web Services (WS)
server (specifically, axis2 server), which listens at port 9090 for all Web Services
requests from WS clients and then sends the result back to the clients.
Quantum DXi-Series Command Line Interface (CLI) Guide
"
6-67081-09 Rev B
February 2014
CIFS
7