Checking Readiness on
Source
Aborting Replication of
VTL or NAS
Aborting
Synchronization of VTL
or NAS
Pausing the Replication
Service on the Source
Replication CLI Commands
Note: Before editing replication settings (using --enablerep nas, --disablerep
nas), first disable File/Directory Based replication (using --disable
filedirrep), then add and remove targets (using --add nastarget or --
del nastarget).
DEPRECATED: syscli --checkrepready nas --name <nas_share>
This CLI command allows the admin user to check and verify the status of the
NAS share prior to replicating. The output will show the status of the NAS.
DEPRECATED: syscli --checkrepready vtl --name <vtl_name>
This CLI command allows the admin user to check and verify the status of the
VTL prior to replicating. The output will show the status of the VTL.
syscli --abortrep vtl --name <VTL_name> [--target <host_name_or_ip>]
syscli --abortrep nas --name <NAS_share_name> [--target
<host_name_or_ip>]
The CLI allows the admin user to abort the current replication of the VTL or NAS.
For the --target option: If the system or the share/partition has two targets
configured, you must use the --target option and you must specify a target IP or
hostname. If the system or the share/partition has no target configured,
invoking the commands will result in error.
syscli --abortsync vtl --name <VTL_name> [--target <host_name_or_ip>]
syscli --abortsync nas --name <NAS_share_name> [--target
<host_name_or_ip>]
The CLI allows the admin user to abort the current synchronization of the VTL or
NAS. For the --target option: If the system or the share/partition has two targets
configured, you must use the --target option and you must specify a target IP or
hostname. If the system or the share/partition has no target configured,
invoking the commands will result in error.
syscli --pause replication [--target <host_name_or_ip>]
The CLI allows the admin user to pause all or a specified active replication
target(s).
CLI command options:
• --pause: Pauses all or a specified active replication targets.
• --target: If specified, pauses the specified replication target; otherwise, the
pause applies to all targets. If the system or the share/partition has two
targets configured, you must use the --target option and you must specify a
target IP or hostname. If the system or the share/partition has no target
configured, invoking the commands will result in error.
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
47