Quantum DXi V-Series Manual page 129

Network CLI Commands
Interrupt:67 Base address:0x20c0
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2000 errors:0 dropped:0 overruns:0 frame:0
TX packets:2000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:177098 (172.9 KiB) TX bytes:177098 (172.9 KiB)
10.20.184.0/21 dev eth0 proto kernel scope link src 10.20.185.92
10.20.184.0/21 dev eth1 proto kernel scope link src 10.20.185.117
169.254.0.0/16 dev eth1 scope link
default via 10.20.184.1 dev eth0
0: from all lookup 255
32764: from 10.20.185.117 lookup eth1
32765: from 10.20.185.92 lookup eth0
32766: from all lookup main
32767: from all lookup default
WARNING: No Replication IP configured
Command completed successfully.
6 To create a bond using eth0 and eth1 as slaves, enter the following:
[root@rok‐dxi92 DXi]# syscli ‐‐add netcfg ‐‐devname bond0:1 ‐‐ipaddr
10.20.185.92 ‐‐netmask 255.255.252.0 ‐‐gateway 10.20.184.1 ‐‐slaves
eth0,eth1 ‐‐mode RR
You have specified the following data for command "AddNetcfg":
‐‐devname = bond0
‐‐ipaddr = 10.20.185.92
‐‐netmask = 255.255.252.0
‐‐gateway = 10.20.184.1
‐‐slaves = eth0,eth1
‐‐mode = RR
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
7 If you want to remove custom configuration such that the system is restored
with the network configuration values it was shipped with, use the syscli
--undo netcfg command. Remember to reboot the system for these values
to take affect.
Note: --undo netcfg DEPRECATED. No longer applicable in versions 2.1 or
greater.
[root@rok‐dxi92 DXi]# syscli ‐‐undo netcfg
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
119