Quantum DXi V1000 Command Manual page 93

Figure 3 Netcfg Example – 
2 x 2 x 2 Networks
Network CLI Commands
The following syscli sequences can be used to configure a similar setup.
To display the existing configuration:
syscli --list interface
First, delete the default bond configuration with all customer ports connected
together:
syscli --del netcfg --devname bond0
Then configure Eth0 for IPADDR1 and for the replication source, if applicable,
configure GATEWAY1:
syscli --add netcfg --devname eth0 --segments DATA,REP --ipaddr IPADDR1 
--netmask NETMASK1 --gateway GATEWAY1
Then configure Eth0 for the other subnet. If applicable, configure GATEWAY2:
syscli --add netcfg --devname eth0:1 --ipaddr IPADDR2 
--netmask NETMASK2 --gateway GATEWAY2 --segments DATA,MGMT
DXi 6540 With Three Bonds of Two Ports Each
Ensure that the switch ports are appropriately aggregated and the gateways, if
applicable, are configured.
The following syscli sequences can be used to configure a similar setup.
To display the existing configuration:
syscli --list interface
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
85