Disabling Nas Share Replication Options On The Source; Checking Readiness On Source; Aborting Replication Of Vtl Or Nas; Aborting Synchronization Of Vtl Or Nas - Quantum DXi V1000 Command Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Disabling NAS Share
Replication Options on
the Source
Checking Readiness on
Source
Aborting Replication of
VTL or NAS
Aborting
Synchronization of VTL
or NAS
Pausing the Replication
Service on the Source
Resuming the
Replication Service on
the Source
42
Note: The target system must have the corresponding NAS share configured
with a Sync ID prior to configuring the source system partition. Refer to
Enabling NAS File/Directory Based Replication on the Target
page 49.
syscli --disablerep nas --name <nas_share> [--nodaily] [--nofiledirbase]
This CLI command allows the admin user to disable the replication feature and
its options on a NAS share. If the --nodaily option is specified, the replicate daily
option is disabled. If the --nofiledirbase option is specified, the file/directory
base replication option is disabled. If no option is specified, the whole
replication is disabled for the specified NAS share, including the daily and file/
directory base replication options.
syscli --checkrepready nas --name <nas_share>
This CLI command allows the admin user to check and verify the status of the
NAS share prior to replicating. The output will show the status of the NAS.
syscli --checkrepready vtl --name <vtl_name>
This CLI command allows the admin user to check and verify the status of the
VTL prior to replicating. The output will show the status of the VTL.
syscli --abortrep vtl --name <VTL_name>
syscli --abortrep nas --name <NAS_share_name>
The CLI allows the admin user to abort the current replication of the VTL or NAS.
syscli --abortsync vtl --name <VTL_name>
syscli --abortsync nas --name <NAS_share_name>
The CLI allows the admin user to abort the current synchronization of the VTL or
NAS.
syscli --pause replication
The CLI allows the admin user to pause an active replication.
syscli --resume replication
The CLI allows the admin user to resume the previous replication that was
paused.
on
Replication CLI Commands