Quantum DXi V1000 Command Manual page 98

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
90
‐‐gateway = 10.20.184.1
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
[root@rok‐dxi92 DXi]# syscli ‐‐add netcfg ‐‐devname eth1 ‐‐ipaddr
10.20.185.117 ‐‐netmask 255.255.248.0 ‐‐gateway 10.20.184.1
You have specified the following data for command "AddNetcfg":
‐‐devname = eth1
‐‐ipaddr = 10.20.185.117
‐‐netmask = 255.255.248.0
‐‐gateway = 10.20.184.1
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
4 Reboot the system using the syscli --nodemanage --reboot command:
[root@rok‐dxi92 DXi]# syscli ‐‐nodemanage ‐‐reboot
You have specified the following data for command "Nodemanage":
‐‐reboot
Are you sure you want to proceed? [yes|no] > yes
Broadcast message from root (pts/1) (Wed Jun 8 09:51:50 2011):
The system is going down for reboot NOW!
Command completed successfully.
5 After the system comes back up, display the runtime network values using
syscli --show netcfg. They should now reflect the configured network
values. The output should now show eth0 and eth1 as independent
interfaces.
[root@rok‐dxi92 DXi]# syscli ‐‐show netcfg
eth0 Link encap:Ethernet HWaddr 00:50:56:AB:00:48
inet addr:10.20.185.92 Bcast:10.20.191.255
Mask:255.255.248.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:373 errors:0 dropped:0 overruns:0 frame:0
TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:32420 (31.6 KiB) TX bytes:9160 (8.9 KiB)
Interrupt:51 Base address:0x2080
eth1 Link encap:Ethernet HWaddr 00:50:56:AB:00:56
inet addr:10.20.185.117 Bcast:10.20.191.255
Mask:255.255.248.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:260 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:21262 (20.7 KiB) TX bytes:168 (168.0 b)
Network CLI Commands