Quantum DXi V1000 Command Manual page 286

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
278
Error Code Error Message
E8050012 Cannot determine if eth file belongs to a bond.
E8050013 An error occured setting the MTU to enable jumbo frames.
E8050014 Cannot write network config file to persist jumbo frame
setting.
E8050015 Invalid network device specified.
E8050016 No matching network device exists.
E8050017 An error occured getting the MTU to get jumbo frame status.
E8050018 An error occured getting the gateway.
E8050019 An error occured getting the default gateway.
E8050020 An error occured getting the hostname.
E8050021 Confignetseg: Failed Processing options using getopt for
confignetseg.sh
E8050022 Confignetseg: Too many arguments for QUERY.
E8050023 Confignetseg: Too many arguments for XML.
E8050024 Confignetseg: Hostname is missing.
E8050025 Confignetseg: Too many arguments RESTARTALL.
E8050026 Confignetseg: Too many arguments for STOPALL.
E8050027 Confignetseg: Too many arguments for STARTALL.
E8050028 Confignetseg: Too many arguments for DEFAULTS.
E8050029 Confignetseg: Gateway IP address is missing.
E8050030 Confignetseg: Segmented IP Addresses for Management,
Data, and Replication are required.
E8050031 Confignetseg: Duplicate segmented IP Addresses for
Management, Data, and Replication are not allowed.
E8050032 Confignetseg: Netmasks for the segmented IP Addresses for
Management, Data, and Replication are required.
E8050033 Confignetseg: Default gateway is invalid.
E8050034 Confignetseg: For using segmented networking, the
segmented IP Address's should be in different subnets.
E8050035 Confignetseg: ALL_1 BONDING with no SEGMENTATION
requires a BONDIP, BIPNETMASK and ETH5IP, EIP5NETMASK.
E8050036 Confignetseg: ALL_1 BONDING with no SEGMENTATION
requires a BIPNETMASK for BONDIP and EIP5NETMASK for
ETHIP5.
CLI Error Codes