Warming Up The Engine - TOHATSU MFS 4C Owner's Manual

MFS4-5-6C_EUR_EN_141119N.book 34 ページ ２０１４年１２月６日 土曜日 午後７時４２分
34
ENGINE OPERATION
5. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
ENOW00860-0
CAUTION
Be sure to keep the harness away from the
7
rotation parts.
6. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
7. Set the control lever in the Neutral
position.
8. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
9. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00043-A

3. Warming up the engine

ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
ENOF00435-0
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5 ℃ )
5 minutes at 2000 rpm : below 41°F (5 ℃ )
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1. Cooling water check port
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 rpm
for several minutes.
Clutch in (In gear)
1100 rpm
ENOF00436 0
CAUTION
1
ENOF00437-0
Clutch off (Out of gear)
13000 rpm