Table of Contents
Advertisement
13
BRAKE SYSTEM
13.2
Adjusting the basic position of the hand brake lever
When the ABS control unit detects a locking tendency in a wheel, ABS begins regulating
the brake pressure. The regulating process causes a slight pulsing of the hand and foot
brake levers.
ABS warning lamp
starting off. If it does not go out after starting off or if it lights up while riding, this indicates
a fault in the ABS system. In this case, the ABS is no longer enabled and the wheels may
lock during braking. The brake system itself stays functional; only ABS control is not
available.
The ABS warning lamp may also light up if the rotating speeds of the front and rear
wheels differ greatly under extreme riding conditions, for example when making wheelies
or if the rear wheel spins. This causes the ABS to switch off.
To reactivate the ABS, the vehicle must be stopped and the ignition switched off. The
ABS is reactivated when the vehicle is switched on again. The ABS warning lamp goes
out when you start off.
Button
can be used to switch ABS off manually (see Starting).
–
Adjust the basic position of the hand brake lever to your hand size by turning adjust-
ing wheel
Info
Push the hand brake lever forward and turn the adjusting wheel.
Do not make any adjustments while riding.
H00411-10
must light up after the ignition is switched on and go out after
.
108
Advertisement
Table of Contents
