11
TUNING THE CHASSIS
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
Preparatory work
–
Raise the motorcycle with the work stand.
–
Remove the seat. (
–
Take off the side cover. (
–
Remove the air filter box.
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Loosen retaining ring
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length while the spring is not under tension.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload
201271-11
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten retaining ring
Finishing work
–
Install the shock absorber.
p. 90)
p. 91)
.
until the spring is no longer under tension.
21 mm (0.83 in)
.
to the specified measurement.
80