12
SERVICE WORK ON THE CHASSIS
12.22
Checking the chain, rear sprocket, engine sprocket, and chain guide
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the adjusting screws
and right chain adjusters
marks
Info
The upper part of the chain must be taut.
Chain wear is not always even. Repeat this measurement at different chain
positions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
H00406-10
Guideline
Nut, rear wheel spindle
Preparatory work
–
Raise the motorcycle with the rear wheel stand. (
.
.
on the left and right so that the markings on the left
are in the same position relative to the reference
. The rear wheel is then correctly aligned.
.
are fitted correctly on adjusting screws
.
left and right.
5 mm (0.2 in)
M25x1.5
90 Nm (66.4 lbf ft)
p. 84)
99
.