11
TUNING THE CHASSIS
–
Remove screws
to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
–
Place the handlebar support in the required position. Mount and tighten screws
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps.
102145-10
–
Mount screws
–
Screw the handlebar clamps so that both parts touch at the front and tighten all of the
screws.
Guideline
Screw, handlebar clamp
. Take off the handlebar clamps. Remove the handlebar and lay it
. Remove handlebar support
and push through nuts
M10
, but do not tighten yet.
.
from below.
Loctite
45 Nm
(33.2 lbf ft)
M8
20 Nm (14.8 lbf ft)
83
.
®
243™