Overview of wireless sensors
Pro-F sensor
See To install a Pro-F sensor (page 34).
Specifications
Sensor temperature range
Humidity sensor
Motion sensor
Wireless Sensors
Installation Guide
32°F to 104°F (0° to 40°C)
NOTE If temperature exceeds 104°F (40°C), sensor will continue to report
104°F (40°C) until temperature drops below this limit.
0% to 100%, ±3% RH typical. 0.5% drift per year.
Panasonic AMN42122
8
•
Temperature and relative humidity
sensor
•
On-board PIR (passive infrared) motion
sensor
•
Digital non-programmable display shows
temperature, setpoint adjustment value,
and icons to indicate the following:
Occupied (motion
detected)
Unoccupied
Low battery
Transmitting
Sensor is not receiving a
response from the
Wireless Adapter
NOTE Humidity reading can be
seen only in the i-Vu® interface.
•
Wireless
•
Solar-powered—Indoor solar panel
collects ambient light to power the
sensor and send wireless
communication
•
Buttons to:
Switch display between
○
Fahrenheit and Celsius
Turn on the fan
○
Raise or lower the room
○
temperature setpoint.
Maximum adjustment is
defined in the control program.
CARRIER CORPORATION ©2018
All rights reserved