Table of Contents
Advertisement
3
Run SensorBuilder_Setup.exe.
4
Start the SensorBuilder application.
•
If the USB Radio driver installed correctly, the USB Port field should show something similar to the image
below.
•
If the driver did not automatically install correctly, see To install the USB Radio driver (page 25).
5
Click Start.
NOTE The USB Radio can talk to only one application at a time. If you need to run SensorBuilder and SensorScan
simultaneously, you can do either of the following:
•
Use two USB Radios.
•
Turn off communication with the USB radio in the current application, then switch to the other application and
turn on the USB communication.
Step 2: Pair sensors to the Rnet Wireless Adapter
1
In SensorBuilder's Driver pane, right-click the Wireless Adapter and then select Discover devices. Any
Wireless Adapters within radio range will appear in the Devices pane. The Wireless Adapter with the lowest
dB is the one closest to you.
2
In the Devices pane, click the Wireless Adapter, and then click Yes in the Read device configuration box. The
sensor is now in Learn mode and will stay in Learn mode while SensorBuilder is open.
NOTE The Wireless Adapter is locked during Learn mode so that no other user can configure it. If any other
user clicks on it in the Devices pane, they will see a small red lock on it. Learn mode ends, unlocking the
device, when you close SensorBuilder or you right-click the Wireless Adapter and select End LEARN mode.
Should you delete the Wireless Adapter from the Devices pane or clear the Devices list while the Wireless
Adapter is in Learn mode, the Wireless Adapter will remain locked for 5 minutes.
3
Optional: In the Devices pane, right-click the Wireless Adapter, and then select Rename. In the Short
description field, enter an intuitive name that denotes the location or use of the Wireless Adapter, and then
click Save. The name is stored in SensorBuilder for the device ID.
4
Install each sensor's battery. See the appropriate battery installation instructions in Installing the Wireless
Adapter and sensors (page 30).
NOTE The Pro-F has a built-in battery.
Wireless Sensors
Installation Guide
Pairing sensors to the Wireless Adapter using SensorBuilder
23
CARRIER CORPORATION ©2018
All rights reserved
Advertisement
Table of Contents
