Using Sensorscan And Sensorbuilder To Test Control Program Logic - Carrier WIRELESS STANDARD SENSOR Installation Manual

Using SensorScan and SensorBuilder to test control program logic

You can use SensorScan to simulate a sensor and send values to the i-Vu® application to test control program
logic.
PREREQUISITE 2 USB Radios to run SensorScan and SensorBuilder simultaneously
1
Open SensorScan.
2
Open SensorBuilder, selecting a different USB Radio than the one SensorScan is using.
3
Select the type of sensor you want to simulate in the Profile drop-down list.
4
Press
5
In SensorBuilder, pair that simulated sensor to your Wireless Adapter. See Pairing sensors to the Wireless
Adapter using SensorBuilder (page 22).
6
In SensorScan, type a value in the green text field, and then click
the Wireless Adapter.
Wireless Sensors
Installation Guide
to send a signal to SensorBuilder.
Using SensorScan and SensorBuilder to test control program logic
29
to send the message to
CARRIER CORPORATION ©2018
All rights reserved