Installing the Wireless Adapter and sensors
LED
The blue LED on the top of the Wireless Adapter indicates the following:
If the LED is...
Off
Blinking
Steadily on
To install a Standard or Plus sensor
he sensor can be mounted directly on a wall or mounted to a backplate.
1
Loosen the setscrew, and then remove the mounting plate.
Setscrew
2
With the setscrew at the bottom, attach the mounting plate to the wall using the provided mounting screws.
3
Insert the 1/2 AA 3.6V 1200 mA battery into the battery socket.
Wireless Sensors
Installation Guide
Then the device...
Is not powered or there is a problem.
Is working properly.
Has a problem. Do one of the following:
•
Cycle power to the device.
•
Insert a small screwdriver or paper clip into the hole next to the LED to reboot the
device.
32
CARRIER CORPORATION ©2018
All rights reserved